top of page

Why Is My Water Pressure Suddenly Low in My Ontario CA Home?

Oct 30
6 min read

You don't often consider water pressure when it's flowing just the way you expect.


Low Water Pressure

You turn on the shower and it has enough pressure to rinse the shampoo from your hair.


You rinse the last of the dishes down the drain and it all goes away.


One morning, you turn on the sink and you notice that something seems off.


The water is still running, just not with the pressure you've come to expect.


Maybe your shower suddenly seemed weak or filling up a pot at the kitchen sink took an

unexpected amount of time.


Perhaps you notice that the pressure suddenly drops when somebody else in the house turns

on another fixture.


Low water pressure can stem from several different sources, not all of which are serious

plumbing problems.


The trick is determining if you're dealing with a single fixture, part of the house, or the

plumbing system as a whole.


If the water pressure in your Ontario CA home suddenly doesn't seem right, then read on for

our suggestions on where to begin.


Is it just a single faucet?


Before jumping to the conclusion that your entire plumbing system is to blame, try another

fixture.


If the bathroom sink has less pressure than the shower or the kitchen faucet, then the issue

probably lies closer to the problem faucet.


Mineral buildup can accumulate in the aerator or showerhead, restricting the amount of

water that flows through them.


That's particularly worth checking on if the pressure suddenly became an issue rather than

changing gradually over time.


Remove the aerator if you're comfortable doing so and take a look at it. If you can see

mineral buildup on it, then cleaning it may resolve the issue.


If a single fixture is exhibiting strange behavior while everything else seems fine, then you can

try small steps.


What if the entire home has low pressure?


Now we're talking about a completely different set of circumstances.


Try several fixtures in different locations in the home.


Check both hot and cold water.


If the kitchen, bathrooms, showers, and outside faucets all seem to have weak pressure, then

the issue most likely isn't the aerators.


Something in the water supply prior to reaching your fixtures is most likely to blame.


Now is the time to consider when the issue began.


Did the pressure suddenly change?


Has it been slowly getting worse?


Does it only happen at certain times?


These are all factors that help us narrow down the issue.


Consider if a shutoff valve is partially closed


Sometimes the simplest explanations prove to be the most accurate.


If recently plumbing was serviced on the house, it's possible that a shutoff valve was closed

but not reopened fully.


A partially closed shutoff valve will restrict the amount of water that can move through the

plumbing and can make an entire home feel like it has less pressure.


If you know the location of your main shutoff and feel comfortable inspecting it, you can

check if it's fully open.


Don't force an older valve that is uncooperative.


If you aren't completely certain what you're looking at, it's better to have a plumber check it

than to create another plumbing issue while trying to investigate the original one.


Could a plumbing leak affect the water pressure?


It can.


If there is a leak in the plumbing ahead of your fixtures, then expect a change in the pressure

at the fixtures.


The more interesting question is if you have other signs that point to a leak.


Has the amount of water you use gone up?


Does your water meter indicate that you're using water when you know that nothing is

running?


Have you noticed water dripping or any musty smells?


A pressure change alone is not always sufficient to suggest that a leak is occurring.


A pressure change plus a sudden increase in water usage would make us more curious, but if

you're seeing multiple symptoms then our guide to how to tell if you have a hidden water leak

in your Ontario CA home has the other symptoms worth considering.


What about a leak underneath the house?


This is where some people go straight to the worst case scenarios.


The pressure in the shower suddenly dropped and now they suspect that a pipe broke

underneath the house.


A slab leak is certainly a possibility, but low pressure alone doesn't point directly to it.


Look for other symptoms.


A warm spot on the floor can sometimes point towards a leaking hot water line underneath

the slab.


Unexplained water usage is another sign worth investigating.


You may hear water moving in the walls even when nobody is running a fixture.


If those symptoms sound familiar, then see our guide to the signs of a slab leak in your


The key is combining symptoms rather than deciding what the underlying issue is based on a

weak shower.


Mineral buildup can also affect the water flow


Southern California homeowners are likely to have seen the white mineral buildup that

sometimes comes with the fixtures.


Minerals in the water don't always stay out of the way.


Over time mineral buildup can affect fixtures and some parts of the plumbing system.


Sometimes removing or cleaning an affected fixture solves the issue.


Other times, especially when multiple fixtures are affected, it can be worth investigating

further.


This is another reason that it helps to decide if the issue is isolated or house-wide.


Does the pressure drop when two things are

running at the same time?


Try this test sometime.


Turn on the shower and have another person turn on a second faucet.


A slight change in the pressure is not unusual.


If the shower seems to completely give up whenever another fixture is turned on, then

something may be restricting the amount of water available to the house.


That could involve the plumbing, a valve, supply conditions, or something else that would

need to be investigated.


Watch out for whether this is something that your house always did or if it's a recent

development.


A change is often more interesting to us than the pressure number itself.


The hot water pressure is low but the cold water

pressure is fine


This points to another helpful symptom.


If the pressure is only an issue when hot water is running, then the issue may be on the hot

side rather than the entire home's water supply.


Check more than one fixture.


If the cold water pressure is fine throughout the house but the hot water is noticeably weaker

everywhere, then let your plumber know.


That difference can help save a lot of time when deciding where to begin looking.


We've already covered several of the common water heater issues in our Water Heater


What if the cause can't be found?


This is where continuing to guess doesn't get us very far.


You've checked multiple fixtures.


You've looked for obvious leaks.


Nothing seems to be partially shut off.


The pressure is still different.


If you suspect that water may be escaping from somewhere that you can't see, professional

leak detection in Ontario CA can help determine if a hidden leak is playing a part in the

situation.


That doesn't mean that every low pressure call turns into a leak detection call.


Sometimes the cause is much simpler.


The goal is to figure out which problem you actually have before deciding what needs to be

repaired.


Frequently Asked Questions


Why did my water pressure suddenly get low?


Possible causes for low water pressure include a fixture issue, a partially closed valve, a

plumbing leak, mineral buildup, or an issue with the home's water supply. Checking whether

the issue affects one fixture or the entire house is a useful start.


Can a hidden water leak cause low pressure?


It can. If water is escaping from the plumbing system, the pressure at your fixtures will

change. Look for additional signs such as unexplained water usage, moisture, or a meter that

continues to move when everything is turned off.


Why is only my shower pressure low?


If the pressure at other fixtures is fine, the showerhead itself may be restricted by mineral

buildup or another local issue.


Why is my hot water pressure lower than my cold water

pressure?


When only the hot side is affected, the issue may be somewhere within the hot water system

rather than the entire main water supply. A plumber can inspect the system and determine

what is restricting the flow.


Don't get used to water pressure that suddenly

changed


People are surprisingly good at getting used to minor house issues.


The shower gets weaker and then you barely think about it.


The kitchen faucet takes longer to fill a pot and you just wait.


If the water pressure in your home used to be fine and suddenly isn't, something has changed.


It may turn out to be something simple or it may turn out to be a sign of a plumbing problem

that isn't visible yet.


Royalty Plumbing helps homeowners throughout Ontario and the surrounding Inland Empire

diagnose plumbing issues including hidden water leaks and professional leak detection.


If your water pressure has changed and you can't figure out why, give Royalty Plumbing a

call. Finding the actual cause makes a lot more sense than getting used to a shower that gets

a little worse every month.

 
 
 

Comments


bottom of page